How a Human Hair Wig Can Be Resurrected at Home ？

Human Hair Wigs are surreal, gorgeous, and natural after purchase. They give you the best and allow you to taste the goodness of their natural texture. However, your human hair wigs can lose their shine over time, becoming lifeless, dry, frizzy, and brittle. Here are some reasons why;

You might be wearing an old wig.  After some time, it's common for it to lose its luster.
 Another factor that could be causing your wig to lose its shine is poor care.  Since human hair is used to produce them, human hair wigs appear more lifelike, but improper maintenance might cause them to lose their luster sooner than you might expect.  This implies that you need to take good care of your wig by knowing what it needs.  This post will include further wig maintenance advice.

Hot styling tool use on a regular basis may potentially be the reason.  Heat-styling products, including as flat irons and curling irons, might harm the strands of your wig.  So, avoid or minimize the use of hot tools.

There is a need to bring your human hair wig back to life, even though there are several reasons why it might not be.  Therefore, take a few minutes to think before discarding the wig.  To bring your human hair wig back to life, follow these procedures.

How to Revive a Human Hair Wig at Home

1. Start with Untangling the Knots

This aspect is very technical. That's because you don't want to tug or pull the hair out. What you'll be doing is the opposite.

So, get a wide-tooth comb or a wig brush, and brush your wig. You want to be very careful.

If you'd like to make the process easier, place your wig on a mannequin and secure it in place.

Then, section the hair and start brushing. You can also use your fingers to help loosen some knots.

Move from the ends upwards till you reach the roots. If it's difficult, use a detangling spray or leave-in conditioner on the hair. These two products can help.

2. Dip into Shampoo Mixture

Once you've detangled it, get lukewarm water into a bowl or sink and add a little quantity of shampoo.

Now, swish the wig in the water and shampoo mixture, then rinse out with water. Remember, while it's in the bowl, do not scrub or rub the hair. That way, you will preserve your wig strands.

If your wig is still dirty, apply shampoo all over the hair once more to cleanse it before moving to the next step.

3. Deep Conditioning Session

Squeeze out the excess water carefully then get ready to deep condition your wig. What the conditioner does is restore its shine, vitality, and texture. You can say goodbye to the dullness and dryness if you do this.

So, go in with your deep conditioner first, brush out the hair while the product is on, then leave it for 10 minutes before rinsing it.

Brushing the wig while the conditioner is there helps to saturate and distribute the product you applied evenly.

4. Go For More Moisture

To revive a wig you'll need all the moisture you can get. So, after the deep conditioning, go in with a leave-in conditioner, natural oil, or a hair serum. Brush the hair with your wig brush or wide-tooth comb then set it aside to dry.

Tip: It's best if you air-dry it.

5. Style the Wig

Once your wig is completely dry, place it on a mannequin, and let's get it looking luscious again.

To start, apply a hair serum and brush the hair properly. If you'd like to style with a heat styling tool, it is necessary to apply a heat protectant to your strands for protection. Once you've done this, you can begin blow drying on low heat while you run your brush through the strands.